TYPE 7/16(L29) is one kind of thread coupling RF coaxial connector. Characteristic impedance is 50ohm. The characteristic of connector is in big power, low VSWR, less attenuation, low inter-modulation, excellent nature of airtight.
They are used in connection with feeder cables in broadcast, Television, ground launch system, monitoring of radar, microwave communication fields etc. Our company manufacturer produces many kinds of jumper lines, which can reduce your cost on cable.
Model: TEL-DINM.158-RFC
Description
DIN Male connector for 1-5/8″ flexible cable
Material and Plating | |
Center contact | Brass / Silver Plating |
Insulator | PTFE |
Body & Outer Conductor | Brass / alloy plated with tri-alloy |
Gasket | Silicon Rubber |
Electrical Characteristics | |
Characteristics Impedance | 50 Ohm |
Frequency Range | DC~3 GHz |
Insulation Resistance | ≥10000MΩ |
Dielectric Strength | 4000 V rms |
Center contact resistance | ≤0.4mΩ |
Outer contact resistance | ≤1.5 mΩ |
Insertion Loss | ≤0.12dB@3GHz |
VSWR | ≤1.15@-3.0GHz |
Temperature range | -40~85℃ |
PIM dBc(2×20W) | ≤-160 dBc(2×20W) |
Waterproof | IP67 |
Installation Instructions of N or 7 / 16 or 4310 1 / 2″ super flexible cable
Structure of connector: ( Fig1 )
A. front nut
B. back nut
C. gasket
Stripping dimensions is as shown by diagram ( Fig2 ), attention should be paid while stripping:
1. The end surface of inner conductor should be chamfered.
2. Remove impurities such as copper scale and burr on the end surface of the cable.
Assembling the sealing part: Screw the sealing part in along the outer conductor of the cable as shown by the diagram ( Fig3).
Assembling the back nut (Fig3).
Combine the front and back nut by screwing as shown by diagram ( Figs( 5)
1. Before screwing, smear a layer of lubricating grease on the o-ring.
2. Keep the back nut and the cable motionless, Screw on main shell body on back shell body. Screw down main shell body of back shell body using monkey wrench. Assembling is finished.